#411 Ceramic Engine Treatment 300ml

411 CERAMIC is a nano-technical metal treatment based on the element "Boron" for maximized low-friction properties. Provides ultra-low friction, high fuel economy, strong wear protection and increased engine performance. Also reduces noise that has arisen over time in engines, manual transmissions and hydraulic pumps.

ULTRA-LOW FRICTION

Ceramic is the strongest and most friction-reducing type of all oil additives. Contains the active substance (Nano-Bor Crystal Diamond Powder) that is pressed into metal surfaces that are exposed to pressure and an almost diamond-hard protective film is formed. The nano-particles that are not pressed together provide a homogeneous heat distribution and a ball-bearing effect between surfaces with ultra-low friction.

POWER LOSSES

In a standard gasoline engine in normal operation, up to 30% of the engine power is used to overcome friction losses. Power losses between the cylinder/piston, crankshaft bearings and the valve mechanism amount to approximately 80% of these power losses that are processed by the Ceramic treatment.

HIGH REDUCTION

Ceramic creates hard, strong and smooth metal surfaces with ultra-low friction and heat generation. Increases engine performance up to 10% with a fuel reduction between 5 – 12% and reduced CO2 emissions.

GEARBOXES / HYDRAULIC SYSTEMS

Can be used with advantage in manual gearboxes and hydraulic systems to reduce friction, oil temperature and noise, which extends the life of metal components.

BENEFITS

Fuel reduction up to 8%

Increased engine performance <10%

Reduces CO2 emissions <20%

Lowers oil temperature

Very high wear protection

Lower transmission noise

Mixable with all oils

Does not damage catalysts and particulate filters

INSTRUCTIONS FOR USE

Pour directly into the engine oil and provides full effect after about 150 km.

Added at every oil change for maintained performance increase.

AREAS OF USE

All gasoline and diesel engines, compressors, hydraulic systems and manual transmissions.