12V AUTOMOTIVE IP65 CHARGER 12V/4A-12V/0.8A

DC Connector Depending on the application, clips, loops or a cigarette plug (all included) can be connected to the charger.

Less maintenance and aging when the battery is not in use: Storage mode Storage mode kicks in when the battery has not been exposed for 24 hours. In storage mode the voltage is reduced to 13.2 V to minimize gassing and corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to "equalize" the battery. This feature prevents stratification of the electrolyte and sulfation, a major cause of early battery failure.

Protected against overheating and reverse polarity The output current decreases when the temperature increases up to 40 ° C, but the charger will not fail. The output relay protects against reverse polarity connection.

Five LEDs for status and mode indication When connected to the power supply, the STAND-BY-LED lights up. No voltage will be present at the output. After connecting to a battery (battery voltage must exceed 8.5V), a selection can be made from three charging profiles with the MODE button: 1. Current limited t0 0.8A and 14.4V absorption voltage. The red LED <14Ah lights up. 2. Current 4A and 14.4V absorption voltage. The red LED >14Ah lights up. Application: Flooded, AGM or GEL batteries. Ambient temperature 10-35 ° C. 3. Current 4A and 14.7V absorption voltage. The red LED COLD will be on. Application: Flooded, AGM or GEL batteries. Ambient temperature below 10 ° C, or batteries that require a higher charging voltage (e.g. OPTIMA spiral cell batteries). Until the battery is fully charged, the red LED lights up. After the charging process is completed, the red LED FULL. In case of reverse polarity connection, the red LED! will be on

If the red LED STANDBY remains on, even after pressing the MODE button, the connection to the battery is interrupted. The charger always starts in STANDBY mode when connected to the power supply.