12V/5A BLUE POWER IP65 CHARGER + DC CONNECTOR

This way you can see the information from the charger on your smartphone, tablet or computer using the VictronConnect app. The charger has two power positions 5A and 2A. 2a mode is activated by holding the fashion button until the LED indicator for the selected position begins to flash.

- water, dust and chemical resistant

- Smart charging algorithm in seven steps

- Recycling of fully discharged, "dead" batteries

- Automatic power supply function

- Performance at severe cold: down to -30 ° C

- several life -enhancing properties

- low power setting to charge less batteries

- Lithium -ion battery mode

- Setting and configuration, reading voltage and power with Bluetooth Smart

Ultra -high efficiency “green” battery charger:

With up to 95 % efficiency, these chargers generate up to four

times less heat compared to industry standard. And when

The battery well is fully charged reduces power consumption to 0.5 watts,

About five to ten times better than industry standard.

Durable, safe and silent:

- Low thermal load on electronic components.

- Protection against intrusion of dust, water and chemicals.

- Protection against overheating: The output current is reduced when

 The temperature increases up to 60 ° C, but the charger continues to work.

- The chargers are completely silent: no cooling fan or other moving parts.

Reconditioning:

A lead acid battery that has been loaded insufficiently or that has become

discharged for days or weeks will deteriorate on the ground

of sulfate. If discovery in time can sulfate sometimes partially

repaired by recharging the battery with low power up to a higher

voltage.

Recovery function for fully discharged batteries:

Most chargers with protection against reverse polarity do not detect

a battery that has been fully discharged or near zero volts and charges

Therefore, not the battery. The charger Blue Smart IP65, however, tries

to charge a fully discharged battery with low power and resume

normal charge once adequate voltage has been reached across

the battery poles.

The VictronConnect app:

Install, read and configure your charger BLUE

Smart IP65 via your smartphone.

You can see the status of your charger and your battery and

even check the feature of your charger

By using the VictronConnect app. As

Default you can read the voltage and power on

screen.

Storage Mode:

Less corrosion on the positive plates

Even the lower float charge voltage, following

The absorption period, causes network corrosion. It is therefore important

to reduce charging voltage even more when the battery continues is

Connected to the charger for more than 48 hours.

Temperature -compensated charge:

The optimal charging voltage in a lead acid battery varies

Conversely with the temperature. The charger Blue Smart IP65 measures

surrounding temperature during the test phase and compensates for

temperature during the charging process. The temperature is measured again

When the charger is set for low power under float or storage.

Special settings for cold or hot surroundings are therefore needed

not be done.

Lithium ion Battery Mode:

The charger Blue Smart IP65 uses a specific charge algorithm

for lithium -ion batteries (Lifepo4), with automatic lithium ion under

voltage protection reset

Volt

12

Ampere (Ah)

5 Ah

Width (mm)

81 mm

Height (mm)

45 mm

IP Class (IP)

65 IP

Length (mm)

182 mm

Weight (kg)

0.9 kg